User could pre-configure an APM402XL before the module is inserted the slot.The 40G port can be expanded into four 10G ports via new ‘hardware profile portmode’ command, but this command will not retain across stack failover from stack master to standby unit.When a 40G port on APM402XL is expanded into 4 10G ports, these 10G ports cannot be configured as stacking port due to hardware limitation.Upgrade OpenSSH from version 6.8p1 to 7.5p1, and SSHv1 support has been removed, only SSHv2 is supported.Upgrade TLS to TLS1.2, and the support for both TLS1.0 and TLS1.1 have been removed.Upgrade OpenSSL from 1.0.2e to 1.0.2o, and SSLv2 upgraded to SSLv3.Provide protection of Cross-Site Scripting(XSS) attack through HTML Entity Encoding.Security enhancement to protect from Cross-Site Request Forgery (CSRF) attack. Stacking port mode does not survive hot insertion.The port LED on APM402XL module is not blinking when there is line activity and the 40G port is operating in four 10G ports mode.And most of port configuration can be applied except the port expander command, ‘hardware profile portmode’ will fail. One or more ports of an APM card can be configured in stacking mode. Once reloaded with this APM card inserted, those ports would still operate in stacking mode. However, during run time, if the same APM card is hot inserted, the configured stack ports will be restored back to Ethernet mode. User would need to reconfigure them manually for stacking mode after hot insertion.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |